Particle emissions from manual shielded metal arc welding of carbon steel were sampled in a typical industrial maintenance and metal fabrication workplace environment. Particle number measurements over the size range from 14 nm to 10 microm using a scanning mobility particle sizer and an optical particle counter showed that welding produced an approximately lognormal particle mode with a 120 nm count median and a geometric standard deviation of 2.07. This study produced welding particle number concentrations on the order of 2 x 10(5)/cm(3) in the building air 8.5 m away from the welding. Workplace exposure samples were below the current 8-hour American Conference of Governmental Industrial Hygienists mass concentration threshold limit value of 5 mg/m(3). Submicron particles comprised 80% of the total aerosol mass collected by a cascade impactor during welding. The concentration of larger particles was indistinguishable from indoor background. Microscopy showed that the welding emissions are dominated by clusters formed from <0.1 microm primary spheres. These data on the particles resulting from aerosol transformation by natural dilution inside an industrial building can be compared with laboratory-scale studies of welding particulate. The particle number characteristics observed in this study are significant because toxicological hypotheses suggest that number or surface area may be a better metric than mass when evaluating the health effects of fine particles.