Aim: To compare the shaping ability of ProFile and K3 rotary Ni-Ti instruments when used in a variable tip sequence in simulated curved root canals with different curvature and radius.
Methodology: ProFile or K3.06 taper instruments were used to prepare simulated canals of 20 degrees curvature and 5 mm radius (n = 10) and 30 degrees curvature and 3 mm radius canals (n = 10) in resin blocks. All canals were prepared to an apical size 40 at 0.5 mm from the canal terminus using a variable tip crown-down sequence. Pre- and postinstrumentation digital images were recorded, and an assessment of the canal shape was determined using a computer image analysis program. The material removal from the inner and outer wall of the canal was measured at 28 measuring points, beginning 0.5 mm from the end-point of the canal and the data compared using the Mann-Whitney U-test.
Results: In 20 degrees and 30 degrees canals both instruments significantly removed more (P < 0.05) material on the outer wall than the inner wall in the apical half of the canal. For ProFile files there was no significant difference in the amount of material removed on the outer canal wall between the 20 degrees and 30 degrees canals. However, in the K3 groups significantly more (P < 0.05) outer canal wall was removed in the apical area in 20 degrees canals. When comparing both instruments the results showed that in 20 degrees canals K3 instruments removed more outer and inner canal wall than ProFile instruments (P < 0.05) but that there was no significant difference (P > 0.05) between the instruments in 30 degrees canals.
Conclusion: Within the limitation of this study, both rotary nickel-titanium instruments prepared a well-shaped root canal with minimal canal transportation.