Skip to main page content
Access keys NCBI Homepage MyNCBI Homepage Main Content Main Navigation
, 41 (4), 5-17

High Frequency Electromagnetism, Heat Transfer and Fluid Flow Coupling in ANSYS Multiphysics

Affiliations

High Frequency Electromagnetism, Heat Transfer and Fluid Flow Coupling in ANSYS Multiphysics

Cristina M Sabliov et al. J Microw Power Electromagn Energy.

Abstract

The goal of this study was to numerically predict the temperature of a liquid product heated in a continuous-flow focused microwave system by coupling high frequency electromagnetism, heat transfer, and fluid flow in ANSYS Multiphysics. The developed model was used to determine the temperature change in water processed in a 915 MHz microwave unit, under steady-state conditions. The influence of the flow rates on the temperature distribution in the liquid was assessed. Results showed that the average temperature of water increased from 25 degrees C to 34 degrees C at 2 l/min, and to 42 degrees C at 1 l/min. The highest temperature regions were found in the liquid near the center of the tube, followed by progressively lower temperature regions as the radial distance from the center increased, and finally followed by a slightly higher temperature region near the tube's wall corresponding to the energy distribution given by the Mathieu function. The energy distribution resulted in a similar temperature pattern, with the highest temperatures close to the center of the tube and lower at the walls. The presented ANSYS Multiphysics model can be easily improved to account for complex boundary conditions, phase change, temperature dependent properties, and non-Newtonian flows, which makes for an objective of future studies.

Similar articles

See all similar articles

LinkOut - more resources

Feedback