The use of heterogeneous chemistry for the characterization of functional groups at the gas/particle interface of soot and TiO2 nanoparticles

Phys Chem Chem Phys. 2009 Aug 7;11(29):6205-17. doi: 10.1039/b902509j. Epub 2009 May 15.

Abstract

Six gases [N(CH(3))(3), NH(2)OH, CF(3)COOH, HCl, NO(2) and O(3)] were selected to probe the surface of seven different types of combustion aerosol samples (amorphous carbon, flame soot) and three types of TiO(2) nanoparticles using heterogeneous, i.e. gas-surface reactions. The gas uptake to saturation of the probes was measured under molecular flow conditions in a Knudsen flow reactor and expressed as a density of surface functional groups on a particular aerosol, namely acidic (carboxylic) and basic (conjugated oxides such as pyrone, N-heterocycle and amine) sites, carbonyl (R(1)-C(O)-R(2)) and oxidizable (olefinic, -OH) groups. The limit of detection was generally well below 1% of a formal monolayer of adsorbed probe gas. With few exceptions most investigated aerosol samples interacted with all probe gases to various extents which points to the coexistence of different functional groups on the same aerosol surface such as acidic and basic groups. Generally, the carbonaceous particles displayed significant differences in surface group density: Printex 60 amorphous carbon had the lowest density of surface functional groups throughout, whereas Diesel soot recovered from a Diesel particulate filter had the largest. The presence of basic oxides on carbonaceous aerosol particles was inferred from the ratio of uptakes of CF(3)COOH and HCl owing to the larger stability of the acetate compared to the chloride counterion in the resulting pyrylium salt. Both soots generated from a rich and a lean hexane diffusion flame had a large density of oxidizable groups similar to amorphous carbon FS 101. TiO(2) 15 had the lowest density of functional groups studied for all probe gases among the three TiO(2) nanoparticles despite the smallest size of its primary particles. The technique used enabled the measurement of the uptake probability of the probe gases on the various supported aerosol samples. The initial uptake probability, gamma(0), of the probe gas onto the supported nanoparticles differed significantly among the various investigated aerosol samples but was roughly correlated with the density of surface groups, as expected.

Publication types

  • Research Support, Non-U.S. Gov't

MeSH terms

  • Aerosols / analysis*
  • Aerosols / chemistry
  • Gases / chemistry*
  • Nanoparticles / analysis*
  • Nanoparticles / chemistry
  • Soot / analysis*
  • Soot / chemistry
  • Surface Properties
  • Titanium / analysis*
  • Titanium / chemistry
  • Titrimetry / methods*

Substances

  • Aerosols
  • Gases
  • Soot
  • titanium dioxide
  • Titanium