Determination of Absorbed Dose to Water for High-Energy Photon and Electron Beams-Comparison of the Standards DIN 6800-2 (1997), IAEA TRS 398 (2000) and DIN 6800-2 (2006)

J Med Phys. 2007 Jan;32(1):3-11. doi: 10.4103/0971-6203.31143.

Abstract

For the determination of the absorbed dose to water for high-energy photon and electron beams the IAEA code of practice TRS-398 (2000) is applied internationally. In Germany, the German dosimetry protocol DIN 6800-2 (1997) is used. Recently, the DIN standard has been revised and published as Draft National Standard DIN 6800-2 (2006). It has adopted widely the methodology and dosimetric data of the code of practice. This paper compares these three dosimetry protocols systematically and identifies similarities as well as differences. The investigation was done with 6 and 18 MV photon as well as 5 to 21 MeV electron beams. While only cylindrical chambers were used for photon beams, measurements of electron beams were performed using cylindrical as well as plane-parallel chambers. The discrepancies in the determination of absorbed dose to water between the three protocols were 0.4% for photon beams and 1.5% for electron beams. Comparative measurements showed a deviation of less than 0.5% between our measurements following protocol DIN 6800-2 (2006) and TLD inter-comparison procedure in an external audit.

Keywords: Absorbed dose to water; DIN 6800-2 protocol (1997); DIN 6800-2 protocol (Draft National Standard 2006); IAEA TRS-398 protocol (2000); external beam photons and electrons.