Comparison of methods for assessing geometric efficiency on multi-detector CT scanners

Abstract

The aim of the current study was to compare the film method against the method based on a new CT slice detector in assessing geometric efficiency (GE) of x-ray beams utilized by a multi-detector CT (MDCT) scanner. Measurements of GE were performed using radiographic films and a solid state CT slice detector for all beam qualities, collimations and focal spot sizes available on an MDCT scanner. Repeatability of GE measurements was assessed. The radiographic film and the solid state detector methods were compared to each other in regard to efficacy in measuring free-in-air GE. The values of GE determined using the radiographic film method were found to range between 48.5% and 90.6%. Differences between values obtained with the radiographic film method and corresponding values obtained with the solid state detector were less than 10% exceeding 5% for only one case. Both methods show that wide beams have higher GE values compared to thin ones. The use of large instead of small focal spot was found to deteriorate GE values by up to 23.1%. Beam quality did not seem to influence GE of the various collimations. When thin beam collimations are employed, a considerable amount of the radiation is wasted for non-imaging purposes. Both film and solid state probe methods are capable of measuring GE of thin as well as wide collimations. The solid state detector is the easiest to use, however its usefulness is reduced by the fact that it cannot measure dose profiles of beam collimations available for step-and-shoot mode of operation.