Effect of interference screw depth on fixation strength in biceps tenodesis

Abstract

Purpose: The purpose of this study was to assess the biomechanical performance of the long head of the biceps tenodesis with an interference screw with respect to screw depth.

Methods: Twenty-one human cadaveric shoulders were randomized into 3 treatment groups (7 each): interference screw placed flush to the humeral cortex, 50% proud, or fully recessed. Bone density was determined, and subpectoral biceps tenodesis was performed with 8 × 12 mm Bio-Tenodesis screws (Arthrex, Naples, FL). Each construct was cyclically loaded from 5 to 70 N for 500 cycles at 1 Hz and then pulled to failure at 1 mm/s. Relative actuator displacement was calculated from cyclic testing. Maximum load, elongation, linear stiffness, and failure mode were recorded from pull-to-failure testing. Because of numerous failures during cyclic testing, the final load data from the fully recessed group were not statistically analyzed. The remaining groups were compared by use of a 2-tailed, Student unpaired t test and χ(2) analysis.

Results: There was no significant difference in displacement among groups during cyclic testing. Five specimens in the recessed group failed during cyclic testing, whereas 2 specimens and 0 specimens failed in the proud and flush groups, respectively. The maximum loads sustained were 281.6 ± 77.8 N, 184.5 ± 56.3 N, and 209.1 ± 57.0 N for the flush group, 50% proud group, and recessed group (in those specimens surviving cyclical loading), respectively.

Conclusions: Placement of a Bio-Tenodesis screw flush to the humeral cortex is preferred for maximum fixation strength in subpectoral biceps tenodesis. A screw placed to 50% depth may be effective in the laboratory setting, but recessed placement is more variable and requires additional fixation. The fully recessed group resulted in 5 of 7 failures during cyclical loading, with no specimens failing in the flush group.

Clinical relevance: This study shows the importance of determining the optimal depth of interference screw placement during biceps tenodesis to obtain optimal biomechanical performance and reduce the risk of fixation failure.