Background: Marginal adaptation is very important in cast restorations. Maladaptation leads to plaque retention, reduction of mechanical and esthetic properties. The aim of this study was to evaluate the precision of three different impression materials (including: Additional silicone [AS] and condensational silicone [CS] and polyether [PE]) for duplicating master dies.
Materials and methods: Three master dies from an acrylic tooth model-with supragingival and shoulder finishing line was made by using PE: Impergum, CS: Speedex, and AS: Panasil separately. The Ni-Cr copings were prepared from master dies separately. They were placed on the acrylic model and the mean marginal difference was recorded by using a stereomicroscope. Then 30 duplicate test dies were made by using the same impression materials and the marginal gaps were recorded. The comparison was done by one-way ANOVA and SPSS software (Version 13) at a significant level of 0.05.
Results: The mean marginal difference of four walls from Impergum (38.56 um) was the lowest than Speedex (38.92 um) and Panasil (38.24 um). The Impergum had the highest capability in making duplicate dies (P > 0.05).
Conclusion: The Impergum impression material manifested the highest capability in making a better marginal adaptation of duplicate dies but further studies are needed to make a precise decision.
Keywords: Dimensional changes; duplicate dies; impression materials; marginal adaptation.