Direct lead isotope analysis in Hg-rich sulfides by LA-MC-ICP-MS with a gas exchange device and matrix-matched calibration

Wen Zhang; Zhaochu Hu; Detlef Günther; Yongsheng Liu; Wenli Ling; Keqing Zong; Haihong Chen; Shan Gao

doi:10.1016/j.aca.2016.10.040

Direct lead isotope analysis in Hg-rich sulfides by LA-MC-ICP-MS with a gas exchange device and matrix-matched calibration

Anal Chim Acta. 2016 Dec 15:948:9-18. doi: 10.1016/j.aca.2016.10.040. Epub 2016 Nov 2.

Authors

Wen Zhang¹, Zhaochu Hu², Detlef Günther³, Yongsheng Liu¹, Wenli Ling¹, Keqing Zong¹, Haihong Chen¹, Shan Gao¹

Affiliations

¹ State Key Laboratory of Geological Processes and Mineral Resources, Faculty of Earth Sciences, China University of Geosciences, Wuhan, 430074, China.
² State Key Laboratory of Geological Processes and Mineral Resources, Faculty of Earth Sciences, China University of Geosciences, Wuhan, 430074, China. Electronic address: zchu@vip.sina.com.
³ ETH Zurich, Laboratory for Inorganic Chemistry, CH-8093, Zurich, Switzerland. Electronic address: guenther@inorg.chem.ethz.ch.

PMID: 27871614
DOI: 10.1016/j.aca.2016.10.040

Abstract

In situ Pb isotope data of sulfide samples measured by LA-MC-ICP-MS provide valuable geochemical information for studies of the origin and evolution of ore deposits. However, the severe isobaric interference of ²⁰⁴Hg on ²⁰⁴Pb and the lack of matrix-matched sulfide reference materials limit the precision of Pb isotopic analyses for Hg-rich sulfides. In this study, we observe that Hg forms vapor and can be completely removed from sample aerosol particles produced by laser ablation using a gas exchange device. Additionally, this device does not influence the signal intensities of Pb isotopes. The within-run precision, the external reproducibility and the analytical accuracy are significantly improved for the Hg-rich sulfide samples using this mercury-vapor-removing device. Matrix effects are observed when using silicate glass reference materials as the external standards to assess the relationship of mass fractionation factors between Tl and Pb in sulfide samples, resulting in a maximum deviation of ∼0.20% for ^20xPb/²⁰⁴Pb. Matrix-matched reference materials are therefore required for the highly precise and accurate Pb isotope analyses of sulfide samples. We investigated two sulfide samples, MASS-1 (the Unites States Geological Survey reference materials) and Sph-HYLM (a natural sphalerite), as potential candidates. Repeated analyses of the two proposed sulfide reference materials by LA-MC-ICP-MS yield good external reproducibility of <0.04% (RSD, k = 2) for ^20xPb/²⁰⁶Pb and <0.06% (RSD, k = 2) for ^20xPb/²⁰⁴Pb with the exception of ^20xPb/²⁰⁴Pb in MASS-1, which provided an external reproducibility of 0.24% (RSD, k = 2). Because the concentration of Pb in MASS-1 (76 μg g^-1) is ∼5.2 times lower than that in Sph-HYLM (394 ± 264 μg g^-1). The in situ analytical results of MASS-1 and Sph-HYLM are consistent with the values obtained by solution MC-ICP-MS, demonstrating the reliability and robustness of our analytical protocol.

Keywords: Gas exchange device; LA-MC-ICP-MS; Lead isotope; Matrix effect; Sulfide reference materials.