Competitive adsorption and desorption of arsenate, vanadate, and molybdate onto the low-cost adsorbent materials alum water treatment sludge and bauxite

Environ Sci Pollut Res Int. 2018 Dec;25(34):34053-34062. doi: 10.1007/s11356-018-3301-7. Epub 2018 Oct 3.

Abstract

When low-cost adsorbents are being used to remove contaminant ions (e.g. arsenate, vanadate, and molybdate) from wastewater, competitive adsorption/desorption are central processes determining their removal efficiency. Competitive adsorption of As, V, and Mo was investigated using equimolar oxyanion concentrations in single, binary, and tertiary combinations in adsorption isotherm and pH envelope studies while desorption of previously adsorbed oxyanions was examined in solutions containing single and binary oxyanion combinations. The low-cost adsorbent materials used were alum water treatment sludge (amorphous hydroxy-Al) and bauxite ore (crystalline Al oxides). Adsorption isotherm and pH envelope studies showed that Mo had only a small effect in decreasing adsorption of As and V but V and As had substantial and similar effects in reducing adsorption of the other. As had a greater effect than V in reducing adsorption of Mo and it was concluded that the affinity of oxyanions for the surfaces of water treatment sludge and bauxite followed the order As > V >> Mo. In 0.3 M NaCl electrolyte, desorption of previously adsorbed oxyanions amounted to 0.3-3.4% for V and As, and 11-20% for Mo. As had approximately four times greater effect than Mo in increasing desorption of V while V had about three times the effect of Mo in increasing desorption of As. Thus, the order of oxyanions in inducing desorption of the other oxyanions (i.e. As on V and As) was the same as that for adsorption selectivity: As > V >> Mo. Water treatment sludge was a more effective adsorbent than bauxite because it had a greater adsorption capacity for all three anions and, in addition, they were held more strongly so desorption in the background electrolyte was proportionately less. It was concluded that at similar molar concentrations, arsenate would tend to reduce adsorption of vanadate as well as displace vanadate already held on adsorbent surfaces while both anions will compete effectively with molybdate. The limiting factor for simultaneous removal of As, V, and Mo from multielement solutions by adsorption will therefore be the removal of Mo.

Keywords: Bauxite; Competitive adsorption; Desorption; Isotherm; Water treatment sludge; pH envelope.

MeSH terms

  • Adsorption
  • Alum Compounds / chemistry
  • Aluminum Oxide / chemistry
  • Arsenates / chemistry*
  • Arsenates / isolation & purification
  • Hydrogen-Ion Concentration
  • Molybdenum / chemistry*
  • Molybdenum / isolation & purification
  • Sewage / chemistry
  • Vanadates / chemistry*
  • Vanadates / isolation & purification
  • Waste Disposal, Fluid / methods*
  • Wastewater / chemistry
  • Water Pollutants, Chemical / chemistry*
  • Water Pollutants, Chemical / isolation & purification
  • Wetlands

Substances

  • Alum Compounds
  • Arsenates
  • Sewage
  • Waste Water
  • Water Pollutants, Chemical
  • molybdate
  • aluminum sulfate
  • Vanadates
  • Molybdenum
  • Aluminum Oxide