Objectives: To evaluate alveolar ridge dimensional changes of different alveolar ridge preservation techniques after 3 months of tooth extraction and to compare the efficacy of autologous plasma rich in growth factor (PRGF) to the bone substitutes in alveolar ridge preservation and sites left to heal spontaneously.
Materials and methods: Forty patients requiring tooth extraction in the anterior maxilla were randomly allocated to the four following treatment modalities: spontaneous healing (control), natural bovine bone mineral covered with resorbable native collagen membrane (BBM/CM), freeze-dried bone allograft covered with resorbable native collagen membrane (FDBA/CM) and PRGF alone. Cone beam computed tomography (CBCT) scans were taken after surgery and 3 months later. The measurements of height and width (at 1, 3, and 5 mm below the crest) were performed after superimposing the 2 consecutive CBCT scans.
Results: The greatest horizontal alveolar bone resorption at 1 mm below bone crest was observed in the control group (-1.61 ± 1.76 mm, P = .037), whereas the least reduction in width was found in the BBM/CM group (-0.68 ± 0.67 mm, P = .037). The most pronounced alveolar height reduction was observed in the control group (-0.86 ± 0.43 mm), whereas alveolar ridge preservation with BBMC/CM (-0.26 ± 0.91 mm) and PRGF (-0.54 ± 0.86 mm) successfully reduced the alveolar height reduction as compared to the control group.
Conclusions: Alveolar ridge preservation technique in the esthetic zone using BBM/CM or using PRGF is beneficial to reduce horizontal and vertical bone changes.
Keywords: PRGF; alveolar ridge preservation; bone regeneration; platelet-rich plasma; tooth extraction.
© 2020 Wiley Periodicals LLC.