The evolution of microelectronics increased the information acquired by today's biomedical sensor systems to an extent where the capacity of low-power communication interfaces becomes one of the central bottlenecks. Hence, this paper mathematically analyzes and experimentally verifies novel coil and transceiver topologies for near-field communication interfaces, which simultaneously allow for high data transfer rates, low power consumption, and reduced interference to nearby wireless power transfer interfaces. Data coil design is focused on presenting two particular topologies which provide sufficient coupling between a reader and a wireless sensor system, but do not couple to an energy coil situated on the same substrate, severely reducing interference between wireless data and energy transfer interfaces. A novel transceiver design combines the approaches of a minimalistic analog front-end with a fully digital single-bit sampling demodulator, in which rectangular binary signals are processed by simple digital circuits instead of sinusoidal signals being conditioned by complex analog mixers and subsequent multi-bit analog-to-digital converters. The concepts are implemented using an analog interface in discrete circuit technology and a commercial low-power field-programmable gate array, yielding a transceiver which supports data rates of up to 6.78 MBit/s with an energy consumption of just 646 pJ/bit in transmitting mode and of 364 pJ/bit in receiving mode at a bit error rate of 2×10-7, being 10 times more energy efficient than any commercial NFC interface and fully implementable without any custom CMOS technology.
Keywords: bit error rate; figure-8 coils; low-power systems; near-field communication; phase-shift keying; radio-frequency transceivers; single-bit sampling receiver; very high bit rate.