Laboratory and Numerical Analysis of Steel Cold-Formed Sigma Beams Retrofitted by Bonded CFRP Tapes-Extended Research

Ilona Szewczak; Katarzyna Rzeszut; Patryk Rozylo; Malgorzata Snela

doi:10.3390/ma13214960

Laboratory and Numerical Analysis of Steel Cold-Formed Sigma Beams Retrofitted by Bonded CFRP Tapes-Extended Research

Materials (Basel). 2020 Nov 4;13(21):4960. doi: 10.3390/ma13214960.

Authors

Ilona Szewczak¹, Katarzyna Rzeszut², Patryk Rozylo³, Malgorzata Snela¹

Affiliations

¹ Faculty of Civil Engineering, Lublin University of Technology, 36 Nadbystrzycka Str, 20-618 Lublin, Poland.
² Faculty of Civil and Transport Engineering, Institute of Building Engineering, Poznan University of Technology, 5 Marii Skłodowskiej-Curie Str, 60-965 Poznań, Poland.
³ Faculty of Mechanical Engineering, Lublin University of Technology, 36 Nadbystrzycka Str, 20-618 Lublin, Poland.

Abstract

The presented research is a part of a broader study of strengthening methods closely associated with cold-formed sigma steel beams with tapes made of Carbon Fiber Reinforcement Polymer/Plastic (CFRP). The presented results are a continuation and extension of the tests described in previous work by the authors and refer to high-slenderness thin-walled steel sigma beams subjected to a significant large rotation. The main idea of this expanded study was to identify the effectiveness of CFRP tapes with respect to different locations, namely at a bottom-tensioned or upper-compressed flange. Six beams with a cross-section of an Σ140 × 70 × 2.5 profile by "Blachy Pruszyński" and made of S350GD steel with a span of L = 270 cm were tested in the four-point bending scheme. Two beams, taken as reference, were tested without reinforcement. The remaining beams were reinforced with the use of a 50-mm wide and 1.2-mm thick Sika CarboDur S512 CFRP tape, with two beams reinforced by placing the tape on the upper flange and two with tape located on the bottom flange. The CFRP tape was bonded directly to the beams (by SikaDur^®-30 adhesive). Laboratory tests were aimed at determining the impact of the use of composite tapes on the limitation of displacements and deformations of thin-walled structures. In order to perform a precise measurement of displacement, which is, in the case of beams subjected to large rotations, a very difficult issue in itself, the Tritop system and two coupled lenses of the Aramis system were used. Electrofusion strain gauges were used to measure the deformation. In the next step, numerical models of the analyzed beams were developed in the Abaqus program. Good compliance of the results of laboratory tests and numerical analyses was achieved. The obtained results confirm the beneficial effect of the use of tapes (CFRP) on the reduction in displacements and deformations of steel cold-formed elements.

Keywords: adhesive; composite tapes; numerical analysis; reinforcement method; thin-walled cold-formed steel beam.

Abstract

Grants and funding