Powder X-ray diffraction has some inherent advantages over traditional single-crystal X-ray diffraction in accurately determining electron densities and structural parameters due to the lower requirements for sample crystallinity, simpler corrections and measurement simultaneity. For some simple inorganic materials, it has been shown that these advantages can compensate for disadvantages such as peak overlap and error-prone background subtraction. Although it is challenging to extend powder X-ray diffraction-based electron-density studies to organic materials with significant peak overlap, previous results using a dedicated vacuum diffractometer with a large image-plate camera (AVID) demonstrated that it can be done. However, the vacuum setup with the off-line detector system was found to prohibit a widespread use. Fast microstrip detectors, which have been employed at a number of powder diffraction beamlines, have the potential to facilitate electron-density studies. Nevertheless, no electron-density studies even for materials with slight peak overlap have been performed with microstrip detectors. One of the most critical problems has been a difference in sensitivity between microstrip channels, which substantially defines the dynamic range of a detector. Recently, a robust approach to this problem has been developed and applied to a total scattering measurement system (OHGI) with 15 MYTHEN microstrip modules. In the present study, synchrotron powder X-ray diffraction data obtained with OHGI are evaulated in terms of multipole electron densities and structural parameters (atomic positions and displacement parameters). These results show that, even without a dedicated setup and perfect samples, electron-density modelling can be carried out on high-quality powder X-ray diffraction data. However, it was also found that the required prior information about the sample prohibits widespread use of the method. With the presently obtainable data quality, electron densities of molecular crystals in general are not reliably obtained from powder data, but it is an excellent, possibly superior, alternative to single-crystal measurements for small-unit-cell inorganic solids. If aspherical atomic scattering factors can be obtained from other means (multipole databases, theoretical calculations), then atomic positions (including for hydrogen) and anisotropic atomic displacement parameters (non-hydrogen atoms) of excellent accuracy can be refined from synchrotron powder X-ray diffraction data on organic crystals.
Keywords: electron density; molecular crystals; powder diffraction; structural parameters; synchrotron radiation.
open access.