Sodium silicate is thought to mitigate lead release via two mechanisms: by increasing pH and by forming a protective silica film. A pilot-scale study using an excavated lead service line (LSL) fed with water from a Great Lakes source was undertaken to: (1) clearly distinguish the pH effect and the silica effect; (2) compare sodium silicate to orthophosphate and pH adjustment; (3) determine the nature of silica accumulation in the pipe scale. The LSL was cut into segments and acclimated with water at pH 7.1. Median dissolved lead was 197 µg/L in the last 8 weeks of acclimation and dropped to 16 µg/L, 54 µg/L, and 85 µg/L following treatment with orthophosphate (dose: 2.6 mg-PO4/L, pH: 7.9), pH adjustment (pH: 7.9) and sodium silicate (dose: 20 mg-SiO2/L, pH: 7.9), respectively. When silica dose was increased from 20 mg-SiO2/L to 25 mg-SiO2/L (pH: 8.1), lead release destabilized and increased (median dissolved lead: 141 µg/L) due to formation of colloidal dispersions composed mainly of lead- and aluminum-rich phases as detected by field flow fractionation used with inductively coupled plasma mass spectrometry. Si was present in the scale at a maximum of 2.2 atomic % after 17 weeks of silica dosing at 20 mg- SiO2/L. Under the conditions tested, sodium silicate did not offer any benefits for reducing lead release from this LSL other than increasing pH. However, sodium silicate resulted in lower levels of biofilm accumulation on pipe walls, as measured by heterotrophic plate counts, when compared to orthophosphate.
Keywords: Lead corrosion; lead service line; orthophosphate; pH adjustment; sodium silicate; water treatment.
Copyright © 2021. Published by Elsevier Ltd.