Alkaline and acid solubilisation of waste activated sludge

Water Sci Technol. 2021 Jun;83(12):2980-2996. doi: 10.2166/wst.2021.179.

Abstract

The influence of acidic and alkaline conditions on the solubilisation process of waste activated sludge (WAS) was investigated using HCl and NaOH at pH 2, 10, 11 and 12. The rise in concentration of solubilised compounds, the influence of reaction time, and the influence of the concentration of total solids (TS) during the solubilisation process were determined. Physical and chemical tests demonstrated that pre-treatment provided a release of compounds from the sludge floc matrix into the soluble fraction, characterising the solubilisation process. The highest degree of WAS solubilisation was observed when a pH of 12 was applied. Although largest effects were already attained after 0.25 h, WAS solubilisation continued reaching an increase in total dissolved solids by a factor 10.4 after 720 hrs. Under these conditions, the dissolved organic carbon (DOC), proteins, and carbohydrates resulted in releases up to 15, 40 and 41 times, respectively; phosphorus increased 5.7 times. Results indicate that by applying alkaline pre-treatment, higher TS concentrations can be treated per reactor volume compared to non-pre-treated WAS. Aerobic and anaerobic biodegradability tests showed increased bioconversion potentials in full-scale treatment plants. The respirometry tests ratify the improvement in solubilisation, with O2 consumption rates increasing 1.4 times, concomitant with an additional 261 mg·L-1 of the COD used, which represents 90% bioconversion of waste activated sludge. Biomethanisation test indicated an increase of 3.6 times relative to the blank.

MeSH terms

  • Anaerobiosis
  • Carbon
  • Sewage*
  • Waste Disposal, Fluid*

Substances

  • Sewage
  • Carbon