Use of the AE Effect to Determine the Stresses State in AAC Masonry Walls under Compression

Radosław Jasiński; Krzysztof Stebel; Paweł Kielan

doi:10.3390/ma14133459

Use of the AE Effect to Determine the Stresses State in AAC Masonry Walls under Compression

Materials (Basel). 2021 Jun 22;14(13):3459. doi: 10.3390/ma14133459.

Authors

Radosław Jasiński¹, Krzysztof Stebel², Paweł Kielan³

Affiliations

¹ Department of Building Structures and Laboratory, Faculty of Civil Engineering, Silesian University of Technology, 44-100 Gliwice, Poland.
² Department of Automatic Control and Robotics, Silesian University of Technology, 44-100 Gliwice, Poland.
³ Department of Mechatronics, Silesian University of Technology, 44-100 Gliwice, Poland.

Abstract

Safety and reliability of constructions operated are predicted using the known mechanical properties of materials and geometry of cross-sections, and also the known internal forces. The extensometry technique (electro-resistant tensometers, wire gauges, sensor systems) is a common method applied under laboratory conditions to determine the deformation state of a material. The construction sector rarely uses ultrasonic extensometry with the acoustoelastic (AE) method which is based on the relation between the direction of ultrasonic waves and the direction of normal stresses. It is generally used to identify stress states of machine or vehicles parts, mainly made of steel, characterized by high homogeneity and a lack of inherent internal defects. The AE effect was detected in autoclaved aerated concrete (AAC), which is usually used in masonry units. The acoustoelastic effect was used in the tests described to identify the complex stress state in masonry walls (masonry units) made of AAC. At first, the relationships were determined for mean hydrostatic stresses P and mean compressive stresses σ₃ with relation to velocities of the longitudinal ultrasonic wave c_p. These stresses were used to determine stresses σ₃. The discrete approach was used which consists in analyzing single masonry units. Changes in velocity of longitudinal waves were identified at a test stand to control the stress states of an element tested by the digital image correlation (DIC) technique. The analyses involved density and the impact of moisture content of AAC. Then, the method was verified on nine walls subjected to axial compression and the model was validated with the FEM micromodel. It was demonstrated that mean compressive stresses σ₃ and hydrostatic stresses, which were determined for the masonry using the method considered, could be determined even up to ca. 75% of failure stresses at the acceptable error level of 15%. Stresses σ₁ parallel to bed joints were calculated using the known mean hydrostatic stresses and mean compressive stresses σ₃.

Keywords: DIC technique; acoustoelastic effect (AE); autoclaved aerated concrete masonry units (AAC); compressive strength; hydrostatic stresses; masonry structures; minor-destructive (MDT) techniques; modeling; non-destructive (NDT) techniques; ultrasonic testing.