Objective: Anthropomorphic test devices (ATD) are used in crashworthiness studies to advance safety in automotive, military, aviation, and other environments. The Test Device for Human Occupant Restraint (THOR) is an advancement over the widely used Hybrid III ATD. The female version THOR-05F is different from the male as it is not a scaled-down version of the male, and it is based on the recognition that the cervical spines (necks) of females have a different response than males. The objective of this study is to evaluate its response at dynamic rates of loading and compare it with previous postmortem human surrogate (PMHS) responses under sagittal plane bending.
Methods: The head/neck assembly was separated from the thorax, and a lower neck plate was attached to the head/neck assembly to mount the preparation to the frame of an electro-hydraulic testing device. A custom upper neck interface plate was attached to a novel angular displacement test device that converted the linear motion of the vertical electrohydraulic piston to moment loading at the occipital condyle joint. The neck was preconditioned by applying a sinusoidal 10-degree flexion-extension cycle for 90 s and then three repeat dynamic tests at a target rate of 90 Nm/s. Flexion and extension tests were performed with and without the front and rear neck cables of the THOR-05F neck. Targets were fixed to the upper neck adapter plate, occipital condyle joint, mid-spine aluminum puck, and lower neck adapter plate. The targets' three-dimensional positions were measured using a seven-camera optical motion capture system. Upper neck load cell and occipital condyle potentiometer data were sampled at 20 kHz, and loading rates were determined by calculating the sagittal moment slope between 15% and 85% of the signal.
Results: The mean occipital condyle angle versus sagittal moment response from the 12 tests (three tests each with and without cables and under flexion and extension) are given in the body of the manuscript. With and without cables, the loading rates for flexion tests were 89.3 ± 0.5 Nm/s and 86.3 ± 0.4 Nm/s, and for extension tests they were 90.8 ± 1.2 Nm/s and 88.0 ± 1.5 Nm/s. The average peak sagittal moments were 34.2 ± 0.3 Nm and 30.3 ± 0.2 Nm for flexion and 50.6 ± 0.3 Nm and 47.0 ± 0.3 Nm for extension tests. The mean peak occipital condyle angles were 23.5 ± 0.2 deg and 25.3 ± 0.1 deg for flexion and 22.7 ± 0.2 deg and 25.8 ± 0.1 deg for extension.
Conclusion: Using the angular motion as a basis and comparing it with the previously conducted PMHS tests, the THOR-05F neck has approximately twice the stiffness of the human under sagittal plane bending.
Keywords: OC joint; THOR-05F ATD; biofidelity.