Using a probe to retract the long head of the biceps tendon (LHBT) into the joint is common practice for visualizing the extra-articular portions during arthroscopy. However, extra-articular lesions may be missed in up to half of cases. Greater excursion of the LHBT may be achieved with an Allis clamp grasper. Our goal was to quantify portions of the extra-articular LHBT that could be visualized during shoulder arthroscopy with the Allis clamp and probe techniques. Shoulder arthroscopy was performed on 8 forequarter cadaveric specimens in the simulated beach chair position, and the most distal extent of the intra-articular LHBT was marked. The tendon was pulled into the joint with both techniques, and the additional exposed tendon portion was marked. An open approach was performed, and the locations of the 3 marks were assessed relative to total tendon length. Mean LHBT total length was 96.25 mm. Diagnostic arthroscopy allowed visualization of a mean of 21.75 mm of the intra-articular tendon (22.6% of the total length). The traditional probe technique provided visualization of 31.13 mm (32.8%). The Allis clamp technique provided visualization of 49.38 mm (52%) and increased visualization of the LHBT by 58.6% (P<.0001). A mean of 46.87 mm (48%) of the LHBT remained unvisualized. The Allis clamp technique maximizes arthroscopic visualization of extra-articular LHBT. The distal 48% eludes evaluation, but can be visualized when combined with an open technique without the need to divide the transverse humeral ligament. The Allis clamp technique facilitates additional identification of LHBT pathology that could otherwise remain hidden during shoulder arthroscopy. Because the LHBT is a major source of pain in the shoulder, this technique may improve outcomes of shoulder arthroscopy and reduce the need for revision because of remnant anterior shoulder pain. [Orthopedics. 2022;45(1):38-42.].