Vibration Response Analysis of the Tail Beam of Hydraulic Support Impacted by Coal Gangue Particles with Different Shapes

Lirong Wan; Jiantao Wang; Qingliang Zeng; Dejian Ma; Xuehui Yu; Zhaosheng Meng

doi:10.1021/acsomega.1c06279

Vibration Response Analysis of the Tail Beam of Hydraulic Support Impacted by Coal Gangue Particles with Different Shapes

ACS Omega. 2022 Jan 19;7(4):3656-3670. doi: 10.1021/acsomega.1c06279. eCollection 2022 Feb 1.

Authors

Lirong Wan¹, Jiantao Wang¹, Qingliang Zeng^{1

2}, Dejian Ma¹, Xuehui Yu¹, Zhaosheng Meng³

Affiliations

¹ College of Mechanical and Electronic Engineering, Shandong University of Science and Technology, Qingdao 266590, China.
² College of Information Science and Engineering, Shandong Normal University, Jinan 250358, China.
³ State Key Laboratory of Mining Disaster Prevention and Control Cofounded By Shandong Province and the Ministry of Science and Technology, Shandong University of Science and Technology, 266590 Qingdao, China.

Abstract

The existing research on coal gangue identification based on vibration usually assumes that coal gangue particles are ideal shapes. To understand the vibration response difference in hydraulic support caused by coal and gangue with real shapes, this paper uses a three-dimensional (3D) scanning technology to determine the real shape of coal particles. The process of coal and gangue impacting the tail beam at different angles was simulated in the LS-DYNA software package, and the effects of shape parameters, velocity, and coal strength on the difference in vibration signals caused by the two were analyzed statistically. The conclusions are as follows: the vibrational response of the tail beam is concentrated mainly in the area between the ribs. The regularity of the velocity signal caused by gangue is better than the regularity of the velocity signal caused by coal, and the attenuation speed of the acceleration signal of gangue is slower than the attenuation speed of the acceleration signal of coal. The probability distributions of the velocity and acceleration responses were analyzed statistically, and the results show that the results from coal can be well fitted by a logarithmic normal function, and the standard deviations of velocity and acceleration are 0.05591 and 489.8, respectively. The gangue results are fitted by the gamma function and the Weibull function, and the standard deviations are 0.13531 and 737.9, respectively, showing that the fitting function has the potential to be used as the basis for coal gangue identification. The change in coal strength has little effect on the vibration response of the tail beam. With increasingly falling velocity, the vibration signal intensity of the tail beam increases, but the discrimination between coal and gangue weakens; therefore, measures should be taken to reduce the falling velocity of the rock mass. The research results of this paper can provide a reference for further study of coal gangue identification methods based on vibration.