A Novel Method of Si and Si3N4 Powder Resources Recycling: Cold Bonding Briquettes

Yuandong Xiong; Ying Li; Huiting Chen; Dejin Qiu; Shiyu Wei; Henrik Saxén; Yaowei Yu

doi:10.3390/ma15165496

A Novel Method of Si and Si₃N₄ Powder Resources Recycling: Cold Bonding Briquettes

Materials (Basel). 2022 Aug 10;15(16):5496. doi: 10.3390/ma15165496.

Authors

Yuandong Xiong¹, Ying Li¹, Huiting Chen¹, Dejin Qiu¹, Shiyu Wei¹, Henrik Saxén², Yaowei Yu¹

Affiliations

¹ State Key Laboratory of Advanced Special Steel, Shanghai Key Laboratory of Advanced Ferrometallurgy, School of Materials Science and Engineering, Shanghai University, 99 Shangda Road, Shanghai 200444, China.
² Process and Systems Engineering Laboratory, Faculty of Science and Engineering, Åbo Akademi University, Henriksgatan 2, 20500 Åbo, Finland.

Abstract

Silicon nitride (Si₃N₄) and silicon powder (Si) are two kinds of harmful solid waste in industrial production. As an environmental and low-consumption method, the cold-bonding technique is a novel method to utilize the problem of powder resource cycling. In this experiment, mechanical and high-temperature properties of Si and Si₃N₄ briquettes were studied after cold bonding. The results are as follows: (1) The compressive strength of the Si and Si₃N₄ briquettes increased with the improvement of molding pressure. With the same binder (1 wt.%) and water (10 wt.%) addition, the compressive strength of the Si₃N₄ briquette arrived at 12,023.53 N under 40 Mpa molding pressure, which is much higher than that of the Si briquette (942.40 N). The Si particles are uneven and irregular, which leads to an intense arch bridge effect in the Si briquette and the compressive strength decrease. Compared with Si powder, the particle size and shape of Si₃N₄ is small, uniform, and regular. The influence of the arch bridge effect is smaller than that in the Si briquette. (2) After being treated at 1473 K for 1 h, the compressive strength of the Si briquette increased to 5049.83 N, and the compressive strength of the Si₃N₄ briquette had a slight change. The surface of the briquettes was contacted with oxygen and reacted to form an outer shell which mainly contains SiO₂ in the high-temperature treatment. FT-IR results have shown there were no extra impurities in cold-bonded briquettes when using the organic binder. (3) The microstructure of the cross section of the Si and Si₃N₄ briquettes after high-temperature treatment presented that oxygen entered the briquette through the pores and continued to react with the Si and Si₃N₄. The outer shell of the Si briquette grew and thickened continuously with the oxygen spreading in the Si briquette. However, because of the smaller particle size and regular shape, little oxygen diffused in the Si₃N₄ briquette. The outer shell of the Si₃N₄ briquette is fairly thin, so the compressive strength did not change too much.

Keywords: cold bonding; compressive strength; high-temperature properties; silicon; silicon nitride.

Grants and funding

This research was funded by the Program for Professor of Special Appointment (Eastern Scholar) at Shanghai Institutions of Higher Learning (No. TP2015039), National 111 Project (The Program of Introducing Talents of Discipline to University), Grant Award Number: D17002, the Open Project Program of Anhui Province Key Laboratory of Metallurgical Engineering & Resource Recycling (Anhui University of Technology) No: SKF20-01 and Project No: 51974182 supported by NSFC.