The mechanical performance and surface friction of graphene oxide (GO) were found to inversely depend on the number of layers. Here, we demonstrate the non-monotonic layer-dependence of the nanowear resistance of GO nanosheets deposited on a native silicon oxide substrate. As the thickness of GO increases from ∼0.9 nm to ∼14.5 nm, the nanowear resistance initially demonstrated a decreasing and then an increasing tendency with a critical number of layers of 4 (∼3.6 nm in thickness). This experimental tendency corresponds to a change of the underlying wear mode from the overall removal to progressive layer-by-layer removal. The phenomenon of overall removal disappeared as GO was deposited on an H-DLC substrate with a low surface energy, while the nanowear resistance of thicker GO layers was always higher. Combined with density functional theory calculations, the wear resistance of few-layer GO was found to correlate with the substrate's surface energy. This can be traced back to substrate-dependent adhesive strengths of GO, which correlated with the GO thickness originating from differences in the interfacial charge transfer. Our study proposes a strategy to improve the antiwear properties of 2D layered materials by tuning their own thickness and/or the interfacial interaction with the underlying substrate.
Keywords: charge transfer; graphene oxide; layer-by-layer removal; layer-dependence; nanowear resistance; overall removal.