Fragmentation of degraded plastics and release of smaller secondary microplastics is usually attributed to the growth of environmental stress cracks. Analysis of crack patterns derived from chemical degradation can be useful not only for assessing the cause of plastic fracture and evaluating the useful lifetime of a product, but it can also potentially provide valuable information on the generation of microplastics. However, the literature with respect to microplastics generation is generally limited to surface observations of polypropylene and polyethylene. Here, we used ion-beam milling to prepare cross-sections of fragments of 15 plastic products made from five commodity plastics (polypropylene, polyethylene, polystyrene, polyvinyl chloride, and polyethylene terephthalate) that were collected at two beaches in Japan, and then we examined the microstructures of those cross-sections by means of scanning electron microscopy and energy dispersive X-ray spectroscopy. Crack growth in the depth direction was examined to provide insights into microplastic generation behavior. In all of the polypropylene samples, and some of the low-density polyethylene and polystyrene samples, cracks with a depth exceeding 100 μm from the sample surface were observed. Considering that crack growth causes fracture of degraded plastic and microplastic release, these observations suggest the release of sharp-edged microplastics from the crack fracture surface. In contrast, in the high-density polyethylene and polyvinyl chloride samples, crack growth was limited to within 20 μm of the sample surface, suggesting the release of irregularly shaped microplastics and additive particles. The present results suggest that the degradation behavior of plastic products in the depth direction is dependent on the type of plastic.
Keywords: Crack; Cross-section polisher; Energy-dispersive X-ray spectroscopy; Microplastic; Scanning electron microscopy; Weathering.
Copyright © 2023. Published by Elsevier Ltd.