Energy-based Hp(3) measurement using solid-state detector

Abstract

This study aimed to develop an energy-based Hp(3) measurement method using a solid-state detector (SSD). Incident and entrance surface air kerma were measured using an ionization chamber placed free-in-air and in front of an anthropomorphic or slab phantom. Subsequently, three SSDs were placed free-in-air, and half-value layer and readings were obtained. After measurements, an X-ray beam quality correction factor $\left ({{k}}_{{Q},{{Q}}_{\mathbf{0}}}^{{SSD}}\right)$, backscatter factor (BSF) and conversion factor from incident air kerma to Hp(3) (C3) were determined. Then, the incident air kerma by SSD $\left ({{K}}_{{a},{i}}^{{SSD}}\right )$, Hp(3) and Hp(3)/${{K}}_{{a},{i}}^{{SSD}}$ were calculated. The ${{k}}_{{Q},{{Q}}_{\mathbf{0}}}^{{SSD}}$ was almost consistent for all SSDs. The C3 and BSF were found to increase as tube potential increased. The Hp(3)/${{K}}_{{a},{i}}^{{SSD}}$ calculated with the anthropomorphic and slab phantoms were consistent within 2.1% and 2.6% for all SSDs, respectively. This method improves the energy dependence of Hp(3) measurement and can estimate the Hp(3) measurement error for dedicated Hp(3) dosemeters.