Wind erosion is a significant environmental challenge in arid and semi-arid regions, and artificial crust creation on the soil surface has emerged as an effective approach to mitigate this phenomenon. Various methods of crust formation have been proposed to combat wind erosion in these regions. However, a comprehensive study assessing the durability of these crusts against environmental stresses has been lacking. Hence, the primary objective of the present study is to address this critical issue by evaluating the erodibility and surface strength of alkali-activated slag crusts in response to various environmental stressors. These stressors encompass ultraviolet radiation, heating and cooling cycles, wetting and drying cycles, and freezing and thawing cycles. Through wind tunnel tests, erosion rates were measured under different wind velocities and saltation bombardment conditions, while penetrometer tests were conducted to analyze surface strength. The results demonstrate that alkali-activated cementation produced robust crusts, exhibiting an impressive reduction of over 99.9 % in erosion rates compared to untreated samples. However, the introduction of environmental stresses led to a fivefold increase in erosion rates. Freeze and thaw cycles had the most detrimental effect on the alkali-activated cement crusts while heating and cooling cycles had a relatively minor impact. The wetting and drying cycles and UV radiation ranked second and third, respectively, in terms of their destructive effects on crust erodibility. Despite the observed effects, the crusts maintained their efficiency even when subjected to severe environmental stresses. Notably, the erosion rate of the treated crusts after enduring the most severe studied stress, that is five freeze and thaw cycles, was over 250 times lower than that of the untreated samples.
Keywords: Alkali-activated cement; Crust formation; Durability; Environmental stresses; Wind erosion.
Copyright © 2023 Elsevier B.V. All rights reserved.