Biodegradable zinc (Zn) has attracted increasing interest as a material for temporary implants, primarily due to its moderate degradation kinetics. In recent years, additive manufacturing of Zn alloys using the laser powder bed fusion method (L-PBF) has shown promising results. Compared to as-cast Zn alloys, it offers preferable customized solutions for patient-specific temporary biomedical implants. Due to the novelty of these printed degradable biomaterials and due to reported cytotoxic effects of Zn alloys, this study investigates additively manufactured ZnAgCu, ZnAgCuMn, and ZnAgCuTi alloys, both in as-printed and post-processed conditions, with a focus on L929 and SAOS-2 biocompatibility. In this work, we demonstrate that the increased porosity and therefore larger surface areas compared to polished Zn-alloy samples affect their biocompatibility. Minimal to no cell proliferation was observed on and near the Zn-alloy test plates after 24 h. Undiluted extracts from as-cast Zn and L-PBF-manufactured plates were initially cytotoxic to SAOS-2 cells. However, as passivation proceeded, cytocompatibility was significantly increased from day 3 onward. Zn2+ ion release peaked at 24 h and declined significantly from day 2 to day 10. Compared to the other Zn alloys, ZnAgCuMn exhibited the lowest cytocompatibility. Most intriguingly, 3-month surfaces exhibited reduced cytocompatibility to osteoblasts compared to freshly polished samples. The observed in vitro cytotoxicity motivates further investigation of as-printed and post-processed L-PBF-manufactured Zn alloys, aiming to develop novel surface modification strategies to mitigate the initial ion burst responsible for reduced cytocompatibility and to adjust and tailor the overall degradation kinetics to physiologically tolerable levels tailored to the intended clinical application.
Keywords: Zn alloys; additive manufacturing; biodegradation; cytocompatibility; implants; ion release kinetics; laser powder bed fusion.