The construction and evaluation of PM-selective electrodes with a conventional configuration and without internal reference solution are described. Two different PVC membranes were prepared with PM tetraphenylborate dissolved in 2-nitrophenyl octyl ether (type A) or bis (2-ethylhexyl)sebacate (type B). When the electrodes were evaluated in 0.01 M ionic strength solutions, both presented linear responses from 5 x 10(-5) to 1 x 10(-2) M, slopes close to the theoretical value, practical detection limits of approximately 2 x 10(-5) M, reproducibilities of +/- 0.2 mV/day, and a quick response (< 20 s). Using phosphate buffer solutions (pH 6.0), type B electrodes presented a lower practical detection limit and a better reproducibility than type A. Selectivity against several cations was assessed by the separated solutions method, and the type B electrodes were generally more selective. The type B membrane was also used for the construction of tubular electrodes for the automatic analysis of pharmaceutical products by flow injection analysis (FIA). These tubular detectors, evaluated in a low dispersion FIA system, presented better selectivity and sensitivity than the corresponding conventional ones. Several pharmaceutical preparations were analyzed with both conventional and tubular electrodes. The results obtained by FIA presented relative deviations of < 2% when compared with those obtained from the United States Pharmacopoeia monographs.