Implanted neurostimulators are currently in widespread use and allow patients to receive therapeutic nerve stimulation for a variety of conditions. Such devices often make use of long leads extending from the device to the relevant nerve to deliver their stimulation. These leads carry a significant radiofrequency (RF) safety concern for patients who also receive magnetic resonance imaging (MRI) scans. The incident RF energy from the MRI body coil can couple with the lead and produce dangerous levels of heating at the tip of the lead during a scan. Recent studies have shown one useful approach to mitigate this heating is to vary the conductivity of the wire along its length to decrease the coupling of the incoming RF energy from the MRI coil with the long lead. In this study, we adopt a similar approach and extend it by segmenting a long cylindrical lead model into two sections of differing conductivities and assessing the maximum 1g specific absorption rate (SAR) at the lead tip at both 64 MHz and 127 MHz. We also evaluated the effect of insulation thickness as well as conductivity of the phantom on the maximum 1g SAR. An 11-fold reduction in the SAR was achieved when using high conductivity ratios between the two wire segments for the 127 MHz coil and a 2-fold reduction was seen for the 64 MHz coil.Clinical relevance- Design of an implantable segmented lead has potential to mitigate RF heating concerns and open a wider patient population to both 1.5T and 3T MRI scans.