Constructed wetland systems have been widely used in China due to their advantages of good treatment effect, low cost and environmental friendliness. However, traditional constructed wetlands have challenges in application such as deactivation due to filler clogging, difficulty in filler replacement and low adaptability. To address the above problems, this research proposes a modular filler design constructed wetland based on the concept of assembly construction, which can quickly replace the clogged filler without destroying the overall structure of the wetland. Four commonly used fillers were selected and applied to the pilot system of the assembled constructed wetland in this study, in order to investigate the purification effect of the constructed wetland system with different filler module combinations (CW1, CW2, CW3) on the simulated wastewater. The results showed that the filler combination CW1 was the best for the removal of NH4+-N, and for TP and COD, CW2 has the best removal effect. Therefore, the assembled constructed wetland is adjustable and substantially reduces the maintenance cost, which provides technical guidance for its application in engineering.
Keywords: blocking; filler combinations; modular constructed wetland; modularization; purification effect.
© 2024 The Authors This is an Open Access article distributed under the terms of the Creative Commons Attribution Licence (CC BY 4.0), which permits copying, adaptation and redistribution, provided the original work is properly cited (http://creativecommons.org/licenses/by/4.0/).